What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 10:29
The other is “what does a “fuse” do?”
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
A fuse is a non-resetable over current circuit protector.
Edit 2024–10.
but I think this circuit , shows a few more pieces.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
Giant Inland Boulder a Remnant of Ancient Tsunami - Newser
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
Here is a simplified AC power diagram.
Boulder attack updates: Multiple people injured in 'act of terror,' FBI says - ABC News
It seems Mohan does not understand the difference between a comment and an Answer.
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
I post the exact comment here.
Trump's U.S. Steel decision may come later than expected - Axios
These devices are installed between the “hot” and “neutral” and protective ground.
This is where the MOV conducts again, and dissipated the energy.
In schematic diagrams this is the symbol for a fuse:
but this device (an Inductor) … impedes the rapid changes in the current.
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Why Adding More Bananas to Your Diet Could Impact Your Blood Pressure - Prevention
The third is lightning and “how it gets conducted into a home.”
So, the voltage could go up to 500 volts, and the fuse will not open up.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Why does a narcissist act like it's nothing when they hurt you?
For this case there are devices called Metal oxide varistors (MOV).
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
eight
It’s true, cutting calories will make you depressed - The Times
An AC voltage/ current source, and an ac inductive load.
what exactly is a ‘surge’ protector?
2024–10–10[John johnson John Johnson ]
But… the neutral is now “floating” because of the 1 ohm resistance.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
[image of Common-mode choke]
This device then solves the entire problem.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
(Dc diagram shown, AC is similar).
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
2024–10–16 [ OO OLAOYE OYEBODE ]
the problem then depends on "how fast does the fuse operate?".
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
A circuit breaker is similar, but is resettable.
nine
Upvotes:
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
One
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
One is “what exactly is in a ‘surge protector’ ? ”
The bolt then partially travels down the line to your home.
This is where this question deviates from being a 'generic' question, and becomes more specific.
This is 'the assistant's answer'
Because the load is inductive, the current lags the voltage.(by a bit).
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
This one hit behind the barn.
He then asserts :
What is lightning?
There are three different concepts here that are getting confused.
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
a photo is worth a thousand words.
It also is a device that limits the change in current flow.
At one ohm, the resistor has a maximum of 1 watt power.
Barnstars:
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
There are two important concepts here.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
These are simplified answers to the original question, and does not change anything I wrote above.
He then describes Rainy Season and Lightning.
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
[old diagram got deleted by accident]
But it can get overloaded, and no longer works.
He then describes the function of a fuse.
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.
Can the fuse protect the electronic devices from lightning instead of a surge protector.
What does a fuse do?
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
First Sentence:
“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
Now when you have a certain ac resistance, then a current flows in a loop.
so, what happens?
2024–10–14 [Omar Gharbi Omar Gharbi ]
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
At least they know the answer if they wanted it.